- Connect a drive to they system that is known to be functional.
- Wait until the drive is stable. In majority of the cases the LED follows the logic shown below:
- SAS drive – RED LED is on/steady (not blinking)
- SATA drive – RED LED is off
- FC drive - RED LED is on/steady (not blinking)
- SCSI drive – RED LED is off
- Wait until the drive is stable. In majority of the cases the LED follows the logic shown below:
- Confirm that the drive is listed.
- Remove and insert another drive or another bay.
- Repeat on other bays.
- If something is still not detected properly, it is possible that a controller card (HBA) is likely not seated.
- If there are still problems, take a picture/screenshot of the situation, and contact Blancco Technical Support.