Page History

Description

The license information can be checked using Gemalto Sentinel Admin Control Center, which can be accessed by navigating to to http://localhost:1947 on  on your browser's address bar.

Note! For the license check To see your licenses you will need the HASP to have the HASP HL drivers installed. Drivers can be downloaded from from Gemalto download site.

Step by step instructions

To check your In order to check license information from your a HASP-key:

1. Plug in the HASP-key to your machinecomputer
2. Open Sentinel Admin Control Center by navigating to entering http://localhost:1947 on in your browser's address bar
3. From the left panel, select "Features" -tab and you should to see license information on the screenthe license information for your HASP-key (direct path here is http://localhost:1947/_int_/features.html)
   Image Added

For each product there are two different entries in the "Features" -table. The first product row defines the expiration date of the license and the second has the amount of executions it has left. The columns for each license is as follows:

• Key ID, the internal ID number of the HASP-key
• Product, the product ID and name for the product the license applies to
• Feature, type of restriction the product has, each license will have both
  
  • ExpirationDate, the date that the license is valid till
  • Executions, the amount of licenses left
• Restrictions, defines the Expiration Date or Executions for the license

The below example has Blancco Drive Eraser - Volume Edition licenses, where the expiration date is set to Jan 1, 2024 and amount of licenses left is 9977 as defined by the "Restrictions" -column.

Image Added

If the expiration date has been exceeded or you have run out of licenses, the "Restrictions" -column will show as Expired.

Image Added

If you are unable to see the product names and see only the product IDs If you see only product IDs (and not the proper product names) under the "Product" -column, you will need to update the license catalog file . Follow below steps to update the catalogwith the following steps:

1. Download the up to date catalog: Blancco_catalog_definitions.xml
2. Navigate to "Update/Attach"-tab on Admin Control Center
3. Click "Browse..." and select the "Blancco_catalog_definitions.xml" file you previously downloaded
4. Click Apply
   Image Added

After these steps the updated catalogue is attached, you should be able to see correct product names in the "Features"-tab, when you have a HASP-key attached to your machine.

Please see an example of what you should see within the Admin Control Center below - 

Image Removed

Additionally the process can be viewed 3:09 minutes into the video linked below - 

https://www.blancco.com/our-support/support-videos/hasp-migration-migrate-a-legacy-hasp-key/the product names correctly.