This issue has been identified at least for the following devices using an NVIDIA GPU, causing a black screen during boot-up:
HP
ZBook 17 G3
HP
ZBook Studio G5
Dell
Precision 7540
Dell
Precision 7550
Pass the nouveau.modeset=0 parameter to the kernel:
Info
icon
false
... flr=forced nouveau.modeset=0
In the Drive Eraser Configuration Tool:
If the issue still occurs with the "nouveau.modeset=0" booting parameter, additional booting parameters should be tested. Replace the "nouveau.modeset=0" parameter with the one of the additional parameters mentioned below:
Some systems with dual graphics, such as Intel paired with AMD/ATI causes the system to black screen as it can't be brought out of standby correctly.
This issue has been identified at least for the following devices:
System manufacturer
System model
Dell
Vostro 3350
Pass the radeon.runpm=0 parameter to the kernel:
Info
icon
false
... flr=forced nouveau.modeset=0radeon.runpm=0
In the Drive Eraser Configuration Tool:
UI Tab
title
with Dell iDRAC
Booting Blancco Drive Eraser 7 fails on DELL servers with iDRAC virtual console. The user interface goes to a black screen during the boot process and the iDrac virtual console becomes inaccessible.
This issue has been identified at least for the following machines:
System manufacturer
System model
Dell
PowerEdge R630
Dell
PowerEdge R6515
Pass the vga=791 parameter to the kernel:
Info
icon
false
... flr=forced nouveau.modeset=0vga=791
In the Drive Eraser Configuration Tool:
UI Tab
title
FLR Fails
If hard drives are freeze locked, Blancco Drive Eraser will attempt to remove the lock by power cycling the machine: The screen turns black for few seconds before returning. Depending on the booting option used to boot Blancco Drive Eraser or the configured erasure process ("Manual", "Semi-automatic" or "Automatic"), the Freeze lock removal may occur before the GUI starts or right before an erasure process starts. Unfortunately in some hardware configurations the screen might not turn back on, meaning that the freeze lock removal procedure is not properly supported by the machine. In these cases, the suggested procedure is the following:
Try booting Blancco Drive Eraser using the second booting option (Normal startup (native resolution))
If problems arise with the aforementioned booting option (black screen, machine is unresponsive), try booting Blancco Drive Eraser using the first option (Normal startup (safe resolution))
If problems arise during the booting phase, try booting Blancco Drive Eraser using the fourth option (Show startup messages).
More details about issues with the Freeze Lock Removal procedure can be found in this article.
UI Tab
title
Alternative solutions
Expand
If the hard drive light starts blinking indicating the erasure is in progress, you should be able to monitor the erasure remotely via the Blancco Management Console.
If the machine is on (lights are on, fan is running) but the drive light is not blinking, you may be able to control the erasure remotely via the Blancco Management Console.
If the machine is unresponsive (light are off, fan not running), try in order:
Press any keyboard key or push the machine’s power button for 1 second to wake up the machine and restart Blancco Drive Eraser.
Check from the BIOS/UEFI settings that the machine can be suspended and restarted, if the setting exists make sure that it is enabled.
Remove the drive from the machine and connect it to another machine that is properly supported.
Shut down the computer, unplug the drive's signal or power cable, power on the computer, boot Blancco, and then plug the drive's signal or power cable back in when you see the loading progress bar (Note: This method is not recommended by Blancco, as the drive may get damaged in the process).