Page History
- あらかじめ動作確認済みのハードドライブをユニットに接続してください。
- 安定するまで少し待ちます。たいていの場合、LEDの状態が次のように変化します。
- SASドライブ– 赤いLED (点滅せずに点灯し続ける)
- SATAドライブ – 赤いLED消灯
- FCドライブ - 赤いLED点灯 (点滅せずに点灯し続ける)
- SCSIドライブ – 赤いLED消灯
- 安定するまで少し待ちます。たいていの場合、LEDの状態が次のように変化します。
- ドライブがリストに表示されることを確認。
- 別のベイにドライブを接続し同様に確認。
- 期待通りに検出されない場合、コントローラ (HBA) が正しくインストールされていない可能性があります。
- 問題が解決しない場合は状況がわかるように写真やスクリーンショットを撮影してBlanccoテクニカルサポートにご相談ください。
- Connect a drive to they system that is known to be functional.
- Wait until the drive is stable. In majority of the cases the LED follows the logic shown below:
- SAS drive – RED LED is on/steady (not blinking)
- SATA drive – RED LED is off
- FC drive - RED LED is on/steady (not blinking)
- SCSI drive – RED LED is off
- Wait until the drive is stable. In majority of the cases the LED follows the logic shown below:
- Confirm that the drive is listed.
- Remove and insert another drive or another bay.
- Repeat on other bays.
- If something is still not detected properly, it is possible that a controller card (HBA) is likely not seated.
- If there are still problems, take a picture/screenshot of the situation, and contact Blancco Technical Support.