Versions Compared

Old Version 1

changes.mady.by.user Yoshinori Matsumura

Saved on

compared with

New Version 2

changes.mady.by.user Yoshinori Matsumura

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Created dateUpdated dateAffects versionFix version

 

N/AN/A

問題事象

The PXE boot process results in the network interface not being recognised by the Drive Eraser kernel during the initial booting or the parameter's used are not compatible resulting in a failure to configure the interface.

原因

The PXE boot configuration is created so as to best support the majority of systems, however, this can result in the mentioned failures when the combination of kernel parameters used aren't compatible.

解決策

To resolve the PXE boot issue make the configuration changes which are detailed below.

Panel
borderColorgrey
borderStylesolid

Changing the PXE boot parameter's defined in the iPXE.menu file

  1. Open the ipxe.menu (using a text editor) file found in the following location C:\-> inetpub → wwwroot
  2. Locate the line starting "imgargs VMLINUZ.IMG"
  3. Replace ip=:::::eth0:dhcp with ip=dhcp BOOTIF=${netX/mac}
  4. Save the changes